While it does have a slightly smaller fuel tank than other riding mowers, its fuel efficiency more than makes up for it. Starter Solenoid for Husqvarna Most Riders and Zero Turn Mowers 539101714. If you have a push lawnmower, then pull the cord twice or thrice. After applying all the methods with steps, you may still wonder why my Husqvarna lawn mower not starting. Before attempting to start the mower, ensure that the freewheel control - often located at the rear drawbar or under the mower's seat - is set to the "Engaged" position. I probably will have to buy a lot of hardware and spent a lot of time doing it when I can just go buy another lawnmower for a little over $200.Starter for a husqvarna riding lawn mower.
the Crank goes for about $100 w/ shipping. I was thinking of replacing the crank ( I am pretty good with mechanical stuff) but I just don't think it's worth it. Anyways, if anyone has any input on my problem I would appreciated. also as I turn the blade it seems that sometimes it frees up for about 1/4 turn and then I get a lot of resistance again. When I put the lawn mower on it's side with the propelled belt off and the spark plug off the blade seem to have a lot of resistance when I turn it. I have hit a lot of rocks in the past and the blade was pretty chewed up so maybe the problem is there. At this point I am thinking I have a bent crank. I disconnected the belt for the self propel mechanism to see it the issue was there. I then thought it might be the brake for the self propel mechanism. it is easier to pull the cord then at first but I am still getting a lot of resistance. I took off the recoil mechanism (pull cord) off the lawn mower and checked it and it is not getting caught on anything. I changed the oil, flushed the fuel system, change the blade but still having the same problem.
I did note the piston seems like it was getting caught on something at times when I was turning it by hand (I was thinking a possible bent crank). I turned the engine by hand and the piston looks to be going up and down and valves are opening and closing with out a problem. I took off the blade, disconnected the self propelled belt and the took off the cylinder head. I thought it might be the piston that got corroded on the cylinder since it's been a while since I have use the lawn mower( I keep the lawnmower in my garage). I went to start it this year and the cord was extremely hard to pull. I have a Craftman Briggs and Stratton lawn mower self propelled (i have only used it for a few seasons) I am having trouble pulling the cord.
0 kommentar(er)
